Er zijn 2 reacties in dit onderwerp

[Vozzie]

Hy,

Breakout kit question...

@Pascal: The 13th pin on the left bottom is "GND" but according to this table it is "DNC".

Citeren

DNC -> Do Not Connect. These pins are reserved for future use and should not be connected to at this point in time.

Could this result in a future problem after any update?

The table here shows only one ground and 6 DNC pins.

Greetings

[pascalbianca]

I don't know why he put that in his text by that photo but from the official site of the Pi is this the right table.

 Raspberry-Pi-GPIO-Layout-Revision-2-e1347664831557.png   76.42K   7 downloads

But on the internet there are 3 versions of this table , so witch one is right one thats the question.
Al the grounds on my breakout board are conneted to 1 ground of the raspberry so if they should change it , we can modify the breakout board with 1 little change..

Veranderd door pascalbianca, 04 January 2013 - 10:13.

[pascalbianca]

A little update on your question.
I had send a email to one of Raspbian people to get a 100% good answer.
The one you are pointing to is for a 256mb board and the one i showed you is for the 512mb (512 has the mounting holes) thats the one we have and everybody gets if they buy them.